Fort Myers Garages Work Year-Round — Bare Concrete Doesn’t Keep Up
Fort Myers is a car town, a truck town, and a project town. Garages here hold work trucks that never cool down, weekend builds, gym setups, and everything a Lee County summer drives indoors. Bare concrete dusts, stains, and lets the humidity through — a coated floor ends all three problems in one day.
From older McGregor and Villas slabs that need honest crack repair to Gateway and San Carlos Park homes with builder concrete, every install starts the same way: diamond grinding and a moisture test. Lee County humidity is the #1 killer of cheap coatings — we engineer for it on every job.
Built for Lee County Garages
- MVB moisture-barrier primers where Lee County readings demand them
- Hot-tire-proof wear coat for work trucks that park hot
- Older-slab crack and spall repair — McGregor to Tice
- 1-day installs scheduled around your work week
Our Credentials
- Lifetime Residential Warranty
- OSHA 30-Hour Safety Certified
- Fully Licensed & Insured in Florida
- SAM.GOV Registered Contractor
How We Install Fort Myers Garage Floors
The humidity-proof system, step by step
Diamond grinding & moisture test
Every slab is ground to a CSP-2 profile and moisture-tested — Fort Myers humidity makes this the make-or-break step.
Repairs & MVB primer where needed
Cracks and spalls get structural filler; high moisture readings get a vapor-barrier primer before anything else.
100% solids epoxy + full flake
Commercial-grade epoxy with Torginol flake broadcast to rejection — 200+ blends.
UV-stable polyaspartic topcoat
No yellowing, no hot-tire pickup, easy to clean — backed by our lifetime residential warranty.
What Fort Myers Garage Floors Are Up Against
Local conditions, engineered answers
Moisture vapor from below
Lee County’s water table pushes vapor up through slabs, blistering cheap coatings. Testing plus MVB primers is why ours don’t bubble.
Work trucks & hot tires
Diesel trucks parking hot destroy box-store epoxy. Our 100% solids system bonds into ground concrete — permanently.
Older-neighborhood slabs
McGregor, Villas, and Tice concrete carries decades of cracks and patches. We repair first, coat second.
Summer storm mess
Wet season tracks water and grit in daily. A sealed, textured floor rinses clean instead of staining.
What a Fort Myers Garage Floor Costs
Full-flake systems run $5-8 per square foot installed. A typical 2-car Fort Myers garage (450-500 sq ft) lands between $2,400 and $3,800 depending on slab condition; MVB primers and repairs are itemized up front when needed.
Garage Floor Coating in Fort Myers — FAQs
How much does garage floor coating cost in Fort Myers?
Most 2-car garages run $2,400-$3,800 installed ($5-8/sq ft). Moisture-barrier primers or repairs, when needed, are itemized in the quote before we start. Photo quotes are free.
Why do DIY epoxy kits fail so fast in Fort Myers?
Two reasons: no diamond grinding, and Lee County moisture vapor. Kits sit on top of sealed concrete and blister from below. We grind, test, and prime — that’s the difference between 1 year and 20.
Can the floor handle a lifted truck or trailer?
Yes — point loads, hot diesel tires, and trailer jacks are exactly what the 100% solids system with polyaspartic wear coat is rated for.
How long does the install take?
One day for most garages. Walk-on in 24 hours, vehicles in 48-72. We also do evenings-out logistics for busy households.